Motion

From Alessandro's Wiki
Jump to: navigation, search
  • motion detection software:


configuration file

Threshold 40
# Image width (pixels). Valid range: Camera dependent, default: 352
width 640
 
# Image height (pixels). Valid range: Camera dependent, default: 288
height 480
 
# Maximum number of frames to be captured per second.
# Valid range: 2-100. Default: 100 (almost no limit).
framerate 2
 
# URL to use if you are using a network camera, size will be autodetected (incl http://)
# Must be a URL that returns single jpeg pictures or a raw mjpeg stream. Default: Not defined
netcam_url http://localhost:8090/test1.mjpeg
 
 
# Let motion regulate the brightness of a video device (default: off).
# The auto_brightness feature uses the brightness option as its target value.
# If brightness is zero auto_brightness will adjust to average brightness value 128.
# Only recommended for cameras without auto brightness
auto_brightness off
 
# Set the initial brightness of a video device.
# If auto_brightness is enabled, this value defines the average brightness level
# which Motion will try and adjust to.
# Valid range 0-255, default 0 = disabled
brightness 32
 
# Set the contrast of a video device.
# Valid range 0-255, default 0 = disabled
contrast 0
 
# Set the saturation of a video device.
# Valid range 0-255, default 0 = disabled
saturation 0
 
# Set the hue of a video device (NTSC feature).
# Valid range 0-255, default 0 = disabled
hue 0
 
 
############################################################
# Live Webcam Server
############################################################
 
# The mini-http server listens to this port for requests (default: 0 = disabled)
webcam_port 8082
 
# Quality of the jpeg images produced (default: 50)
webcam_quality 50
 
# Output frames at 1 fps when no motion is detected and increase to the
# rate given by webcam_maxrate when motion is detected (default: off)
webcam_motion off
 
# Maximum framerate for webcam streams (default: 1)
webcam_maxrate 1
 
# Restrict webcam connections to localhost only (default: on)
webcam_localhost off
 
# Limits the number of images per connection (default: 0 = unlimited)
# Number can be defined by multiplying actual webcam rate by desired number of seconds
# Actual webcam rate is the smallest of the numbers framerate and webcam_maxrate
webcam_limit 0