Firewall (iptables)
From Alessandro's Wiki
NAT
Network Address Translation NAT
linux powerful firewall
- print out the configuration running:
iptables -L
- or better this will print all input table rules
iptables-save
- some rules:
target prot opt source destination ACCEPT all -- anywhere anywhere ACCEPT icmp -- anywhere anywhere icmp any ACCEPT ipv6-crypt-- anywhere anywhere ACCEPT ipv6-auth-- anywhere anywhere ACCEPT udp -- anywhere 224.0.0.251 udp dpt:mdns ACCEPT udp -- anywhere anywhere udp dpt:ipp ACCEPT tcp -- anywhere anywhere tcp dpt:ipp ACCEPT all -- anywhere anywhere state RELATED,ESTABLISHED ACCEPT tcp -- anywhere anywhere state NEW tcp dpt:ssh ACCEPT tcp -- anywhere anywhere state NEW tcp dpt:http ACCEPT tcp -- anywhere anywhere state NEW tcp dpt:46590 ACCEPT udp -- anywhere anywhere state NEW udp dpt:46720 REJECT all -- anywhere anywhere reject-with icmp-host-prohibited
- apend a rule (to the end of the table) to accept connections on port 5901 (vncserver)
iptables -A INPUT -m state --state NEW -m tcp -p tcp --dport 5901 -j ACCEPT
- show NAT table
iptables -t nat -L iptables -t nat -L -n -v | grep 'IP or anything' iptables -t nat -L -n -v
- netstat-nat, software to display nat connections
netstat-nat -n
- show SNAT connections, run:
netstat-nat -S
- show DNAT connections, type:
netstat-nat -D
saving configuration in a file
iptables-save > backup_iptables
restore conf from a file
iptables-restore < backup_iptables
- this will only enable the configuration while iptables process is restarted, to avoid this, we need to save the configuration:
/etc/init.d/iptables save
- now we can restart/reboot
redirecting connections
from a specified port to an host
iptables -A PREROUTING -d HOSTONE -p tcp -m tcp --dport 80 -j DNAT --to-destination HOSTWO:80 iptables -A POSTROUTING -d HOSTWO -j SNAT --to-source HOSTONE
UFW
The Ubuntu Firewall
- status
ufw status
- ...with line numbers
ufw status numbered
- numbers
ufw insert <number> allow from ... ufw delete <number>
ufw allow from <target> to <destination> port <port number> proto <protocol name>
- allow all traffic on the forward chain (don't do this)
ufw default allow FORWARD
set DEFAULT_FORWARD_POLICY to ACCEPT
/etc/default/ufw DEFAULT_FORWARD_POLICY="ACCEPT"
- denials
ufw deny from 10.0.0.42 ufw deny in on eth0 from 10.0.0.42
- allow ssh's
ufw allow ssh ufw allow 22 ufw allow from 10.0.0.0/24 to any port 22 ufw allow from 10.0.0.20 to 10.0.0.10 port 22
- web ports
ufw allow http ufw allow 80 ufw allow https ufw allow 443 ufw allow proto tcp from any to any port 80,443
- some dbs
Allow MySQL from Specific IP Address or Subnet
ufw allow from 10.0.0.0/24 to any port 3306
Allow MySQL to Specific Network Interface
ufw allow in on eth1 to any port 3306
PostgreSQL from Specific IP Address or Subnet
ufw allow from 10.0.0.0/24 to any port 5432
- routing from eth1 to eth2
ufw route allow in on eth1 out on eth2